Pass-through seals - Vilpe

Show all products

FELT ROOF SEAL

Pass-through seal for round pipes installed on a felt roof

Made of EPDM rubber; operating temperatures between -30 and +90°C

Should be installed with hot bitumen between two felt layers

Clamp

Screw-on hot galvanized clamp for use with the VILPE® Felt Roof Seal

Should be selected based on the size of the seal and pipe

R-FELT SET

Pass-through seal for round pipes installed on a felt roof while retrofitting

Made of EPDM rubber; operating temperatures between -30 and +90°C

Should be installed with hot bitumen between two felt layers

RHS SEAL

Pass-through seal for square pipes installed on a felt roof

Made of EPDM rubber; operating temperatures between -30 and +90°C

Should be installed with hot bitumen between two felt layers

ROOFSEAL RETROFIT SET

Pass-through seal for different kinds of pipes (e.g. mountings for billboards and flagpoles or electrical wires) installed on a metal roof while retrofitting

Made of EPDM rubber; operating temperatures between -30 and +90°C

Should be installed with hot bitumen between two felt layers

ROOFSEAL SET

Pass-through seal for different kinds of pipes (e.g. mountings for billboards and flagpoles or electrical wires) installed on a metal roof

Made of EPDM rubber; operating temperatures between -30 and +90°C

Should be installed with hot bitumen between two felt layers

HT VAPOUR BARRIER SEAL

Vapour barrier seal for pipes installed through the vapour barrier on an inclined or low-pitched roof (height 33 mm)

Made of EPDM rubber; operating temperatures between -30 and +90°C

Should be installed with bitumen if a roof's vapour barrier is made of bitumen, and with a board made of hard material on top of the vapour barrier valve if a roof's underlay material is made of profiled sheet metal

HTH TALL VAPOUR BARRIER SEAL

Tall vapour barrier seal for pipes installed through the vapour barrier on an inclined or low-pitched roof (height 133 mm)

Made of EPDM rubber; operating temperatures between -30 and +90°C

Should be installed with bitumen if a roof's vapour barrier is made of bitumen, and with a board made of hard material on top of the vapour barrier valve if a roof's underlay material is made of profiled sheet metal

PVC ROOF SEAL

Pass-through seal for round pipes installed on a PVC roof

Made of coloured polyvinyl chloride (PVC)

Should be installed with hot air welding

RHS CLAMP

Description: Hot-dip-galvanized clamp for fixing square VILPE RHS Seal. The clamp is chosen according to the pipe size. Contents: Two-piece clamp.

RHS-Felt Retrofitting Seal 80-150

Pass-through seal for square pipes installed on a felt roof while retrofitting

Made of EPDM rubber; operating temperatures between -30 and +90°C

Should be installed with hot bitumen between two felt layers

ROOFSEAL

Description: Pass-through seal for different kinds of pipes (e.g. mountings for billboards and flagpoles or electrical wires) installed on a metal roof. The weather- and ozone-resistant properties of EPDM rubber are the best possible, and it can endure continuous heat stress of +90°C (and intermittently up to +150°C). EPDM rubber also tolerates the acids and alkalis often found in the air in industrial areas. Should be installed with hot bitumen between two felt layers. Dimensions: Available in 6 different sizes with diameters 12-521 mm. Contents: Seal